Rig Mechanic

To utilize my Professional Experience in Drilling Field as Rig Mechanic Professional

• Carry out and execute all required daily/weekly/monthly and 6 monthly,yearly and 4 yearly Preventive maintenance as per version 2000 computerized for all drilling, power generation and well control equipment to ensure proper and efficient operation.
• Ensure of adopting sufficient safety procedures by holding of prejob safety meeting with all involved crew and issue SJA (Safe Job Analysis) and issue work permits as required.
• Follow E.D.C. international safety procedures during drilling and maintenance processes inside and outside its land and off-shore rigs.
• Coordinate with other departments and assist during troubleshooting or repair
• Trouble shooting for all drilling, power generation and well control equipment to reduce repair/shut down time to minimal.
• Carry out Major overhaul for all drilling ,well control equipment

B.Sc. of Engineering (Mechanical).
Faculty Of Engineering, Alexandria University ,Egypt.
Session 1985-90
Grade/Division “Good-73.75%” Mechanical Power Engineering.

• Fundamentals of Hydraulic Circuits Control, Cairo, Egypt.
• Bearing Technology, Cairo, Egypt.
• Gauges Calibration, Cairo, Egypt.
• North Sea Rigs Summer Training, Scotland, Santa Fe.
• Offshore Safety Ind. & Emergency Training, Aberdeen, Scotland.
• Refrigeration and Air Conditioning, Scottish Offshore Training Association Ltd, Aberdeen, Scotland.
• General English Course, Aberdeen Center for English,Aberdeen,Scotland.
• Introduction to Well Control, Santa Fe, Egypt.
• Advanced Firefighting, Abu Dhabi, U.A.E.
• Offshore Sea Survival, Abu Dhabi, U.A.E.
• H2S (Hydrogen Sulphide), Abu Dhabi, U.A.E.
• Effective Presenter Workshop, Abu Dhabi, U.A.E.
• Contract Administration, Abu Dhabi, U.A.E.
• Microsoft Project 2000 Basic, Abu Dhabi, U.A.E.
• Hydraulic Circuit Control, Abu Dhabi, U.A.E.
• VR 2000, Computerized Maintenance System, Cairo, Egypt.
•

• Carry out and execute all required daily/weekly/monthly and 6 monthly,yearly and 4 yearly Preventive maintenance as per version 2000 computerized for all drilling, power generation and well control equipment to ensure proper and efficient operation.
•Ensure of adopting sufficient safety procedures by holding of prejob safety meeting with all involved crew and issue SJA (Safe Job Analysis) and issue work permits as required.
•Follow E.D.C. international safety procedures during drilling and maintenance processes inside and outside its land and off-shore rigs.
•Coordinate with other departments and assist during troubleshooting or repair
•Trouble shooting for all drilling, power generation and well control equipment to reduce repair/shut down time to minimal.
•Carry out Major overhaul for all drilling ,well control equipment.
Main Equipment Dealt With
Drawworks : All brands/Capacities.
Mud Pumps : All brands/Capacities.
Engines : Caterpillar D-399,D-398,3412, 3512 and 3516.
Top Drive : Varco TDS-03,TDS-04,National Oilwell.
Rotary Table : Emsco,National 27-1/2”and 37-1/2”.
Swivel : Oilwell, BJ
Crown Block : All brands/Capacities
Travelling Block : All brands/Capacities
Cranes : Marathon Letourneau.
Deep Well Pumps : S & N, Plegure.
Compressors : Centrifugal, Screw.
Blowout Preventers : All brands, sizes, pressure ratings.
High pressure Hyd. Units : BOP Closing Unit operating pressure 3000 PSI.