Electro-Mechanical Engineer & Control Engineer

To secure a position that will utilize my experience, education, and proven abilities as well as allow for upward mobility to commensurate with achievement.

· Technical Observation: Damage, Wear, Oil leaks Cracks, ECT tool string or component.
· Technical recommend testing troubleshooting actions: comments on confidence test results, verification, Heat test, Extension test, Resistance test, Generator test, Oil sample test.
· Performs quality tests and functional tests on electronic directional and gamma probes. Calibrates probes to within specification. Works closely to procedures and maintains history records of results. Performs non-routine failure analysis and provides technical reports.
· Performs quality confidence tests on down hole pulsing / generator unit including load tests, functional tests and generator output tests (voltage, current, resistance). Performs special vacuum refill of down hole pulser using custom built test equipment to company procedures.
Trained: Alberta, Canada

? Prepare Shaft: Note the importance of matching the Split Thrust Ring and Thrust Ring Taper to the Shaft. Note the use of bonding agent when potting the tubing to the Shaft.

? Bearing Spacing Procedure: It is crucial to ensure a proper fit for the bearings to allow the Focal Bearing to contact the correct locations on the Shaft and ensure that loads are correctly distributed.

? Magnetic Disc Installation: It is crucial that when magnetic discs are installed for use with Hall Effect Switches that they be installed with the south pole facing the switch.

? Main Assembly Procedure: Always prepare beforehand when attempting the various steps in this procedure to ensure that you have all the correct tooling and equipment needed to complete the tasks.

? Measurement for Manifold Belleville Springs: Ensure that tooling does not slip the Shaft during the loading procedure.

? Checking of Electrical Connections: To ensure the electrical integrity of the wires going through the Pump Interconnect.

? Ranging the RPM Sensor: To ensure the correct axial alignment of the Magnet ring in the Anti Rotation Housing with respect to the HET Mandrel on the Shaft.

? Measurement for Electronics Belleville Springs: To ensure the correct axial load is applied to Electronics Insert.

? Low Pressure Testing: To ensure that all seals are intact at various stages during the assembly process.

Bachelor of Science Degree in Electrical Engineering Technology
Alabama A&M University, Huntsville, Alabama, USA

Bently Nevada Saudi Arabia LTD. Optimization & Control.

Operating Systems: Trained to use DOS, Window/95/98/2000
Application Software: Developed many documents, spreadsheets, using Microsoft Office including presentation tools.