Egypt Zones accountACCOUNT

Process Engineer


This is a candidate registered on Gulfoilandgas.com. To contact this candidate you need to purchase a subscription. Go to Recruitment Products >>
Education: 5
Experience: 5 years
Relocation: Yes - Internationally

Industry Experience
5 years Engineer

Career Objective

International experience in process engineering in terms of detail and basic stages in downstream gas plants considering with international standards and design in practices and particular experience in others issues such as pipeline studies.

Professional Experience



SOUTH PARS 17&18 PROJECT:
Client :(POGC Pars Oil and Gas Company www.pogc.org)
· Position:
Process engineer for FEED stage comprising unites such as: Gas sweetening, Dehydration and mercury guard, Ethane recovery, Condensate stabilizing, Ethane sweetening and dehydration, Sulfrex process for LPG treating, Propane refrigeration…
· Generating documents such as: PID, PFD, Design basis, PSV data sheet, CV data sheet, and Process data sheet for equipments…


SIRRI GAS GATHERING AND NGL RECOVERY PROJECT:
· · Client:(IOOC Iranian Offshore Oil Company www.iooc.co.ir)
· Position:
· Experience in Turbo expander.
· Experience in Cold Box.
· Surge analysis for five pipelines in gas plant :( Propane, Butane, Pentane, Condensate, Seawater).
· Hydraulic study for gas sea line.
· Experience in Compressor.
· Experience in Pumps.
· Experience in Dosing Package.
· Experience in Boil-Off System.
· Experience in engineering services for procurement.

SOUTH PARS 9&10 PROJECT:
· From March 2003 to March 2006, involved with design and development for the process and storage facilities in South Pars 9&10 gas field development. · Client :(POGC Pars Oil and Gas Company)
· Position:
Process and utility Engineer as:

HAZOP study for Polishing Package.

Basic engineering experience:

1- Tank and vessel sizing.
2- Pump sizing.
3- Pressure and temperature safety valve sizing.
4- Line sizing.
5- Vertical and horizontal two and three phase separator design.
6- Depressurizing study.
7- Filter data sheet.
8- Columns data sheet.
9- Compressor data sheet
10- Expander data sheet.
11- Cold box data sheet.
12- Utilities Balance.
13- Simulation.
14- Process design criteria.

Detail engineering experience:

1. Control valve sizing.
2. Safety scenarios.
3. Cause an effect matrix.
4. Shut down logic diagram.
5. P&ID and PFD development.
6. Process design criteria.
7. Operating Manual.
8. Generation of documents such as: line list, equipment list, instrument data sheets…
9. Flare purging.
10. VDC (vendor documents/drawing check).
11. Floating roof tank accessories sizing.
12. Dehydrate formation.
13. Column Internals.
14. Isolation Philosophy.
15. Graphic Display.
16. Settle-out pressure.
17. LPG Tanks.

· Familiar with standards and codes to design such as API, GPSA…

Eductation

· M.S in Chemical Engineering from Tehran University in field of Separation Processes, 2005, GPA 17.
· M.S thesis title: Modeling and simulation of depropanizer and debutanizer distillation column.
· B.S in Chemical Engineering from Tehran University, 2002, GPA 16.
· 1st Rank in AZAD University M.S admission Test.

Certification

· HYSIS by EIED.
· PROSIM PLUS by PROSIM Company (French division).
· AFT IMPULSE by EIED.
· Energy management and auditing by International Energy Studies Institute.
· Safety in Process Engineering by International Energy Studies Institute.
· FLOWMASTER by EIED.

Additional Information

Practical Experience

· Design and setup of Ion Exchange column.
· Internal lining and insulation.


Software Skills

· HYSYS, experience simulating in both static and dynamic modes.
· PROSIM PLUS, experience simulating in static mode.
· AFT IMPULS experience in surge analysis and surge suppression.
· PIPEPHASE and PIPESYS experience for hydraulic study.
· ASPEN + experience simulating in static mode.
· FLARENET, Experience in Flare Network rating.
· FLOWMASTER in surge analysis and surge suppression.


Other Major Activities

· Process designer for Interconnecting Condensate Pipe Project between south Pars phases 1to5 by DOIEC (consulting company www.doiec.com) September 2005.
· Client: POGC
· Process designer for Export Gas Pipeline From Iran to Armenia by SISAKHT (consulting company) December 2005.
· Client: NIGC (National Iranian Gas Company www.nigc.org).
· Providing Control valve procedure for EIED process department December 2006.
· Process engineer to design a letdown station for FAJR Utility plant by DOIEC February 2007.
· Client: OXINSANAT (www.oxinsanat.com)

Languages

· Persian and English.
· TOFEL AND IELTS Degree.

Hot Categories

Chemicals Batteries

Are you Hiring?


Reach the right candidates to fill your technical positions with Gulfoilandgas Jobs »
Technical Recruitment
Our Career Center has 70,000+ resumes for employers to search »
200-Engineering Consultants » News » Design/construction/Engineering Graphics » News » Engineering » News » Engineering Services » News » Production Engineering » News » Project & Resource Management » News » Training & Education » News »
Engineer
Mechanical Engineer
Field Engineer
Quality Control/Quality Assurance Engineer
Environmental Health & Safety Associate
Engineering
Technician
Electrical Engineer
Engineering
Petroleum

Field Service Technician
Manager
Information Systems/Technology
Electrical/Mechanical/Structural
Construction Engineer
Civil Engineer
Assistant Manager
Purchasing Management
Chemical Engineer
Project Engineer
Analyst
Engineering
Drilling

Customer Service
Process Engineer
Control Engineer
Project Manager
Electrician
Computer Systems Analyst
Engineering Management
Operations Manager
Specialist
Marketing/Sales Manager
Sales
Construction Technician
Mechanic
Plant Engineer
Driller
Consulting Engineer
Maintenance Manager
Other
Egypt Zones
Copyright © Universal Solutions All rights reserved. - Privacy Policy.