Petroleum or Production Engineer
This is a candidate registered on Gulfoilandgas.com. To contact this candidate you need to purchase a subscription.
Education: 5
Experience: 6 years
Relocation: Yes - Internationally
Career Objective
Petroleum or Production Engineer
Professional Experience
July 2005 to Date : Mentoree in Well control, Boots and Coots Inc/Sonatrach.
June 2002 to 2005: Petroleum Engineer, for Sonatrach Production
Engineering Division, TFT Oilfield, Algeria.
Eductation
MSc (Petroleum Engineering) 2002 – OKLAHOMA UNIVERSITY , USA
B.Sc (Petroleum Engineering) 1997– INHC, Boumerdes, Algeria
Bac Mathematics 1992– SKIKDA, Algeria
Certification
• Wood Group Technical service training of API wellhead equipment, February 2007, Sugar Land, Texas
• Cameron Type U BOP educational course February 2007, Waller, Texas
• Cameron Surface Systems 101,February 2007, Houston, Texas
• Operations Drilling technology and Advanced Well Control Course (Murchison Drilling School, Albuquerque, New Mexico, USA) January 2006
• Wellcap (07/21/2006)
• Safe Gulf (Houma, New Mexico) 2006
• H2S (Houma, New Mexico) 2006
• CPR (Houma, New Mexico) 2006
• Certificate in OFM (oilfield manager), (schlumberger, Algeria) 2003
• Certificate in Interactive Petrophysics. (schlumberger, Algeria) 2003
• Certificate in Well Test Analysis, and Advanced Well-Test Analysis. (schlumberger, Algeria) 2003
Additional Information
Experience with Petroleum Engineering Software
Areas of expertise
Almost 6 years of work experience as Petroleum engineer for Sonatrach – Production Engineering Division (TFT Oilfield - Algeria) where main duties are:
1.well control and wells remediation:
•Underground Blowout studies
•Well integrity and Wellhead Inspection
•Rig audits
•Operational Procedures
•Perform decision and risk analysis and contingency planning
•P & A procedures.
2.Diagnosis and analysis of shut in wells and looking for possible remediation (water shut-off, Re-perforating, acid wash, reservoir stimulation)
3.Well Test:
•Programming of wells for pressure Build Up, Fall Off tests, and static pressure recording,
•Interpretation and analysis
•Designing special well tests such as DST with Coiled tubing for wells with low reservoir pressure.
4.Well Performance: Production optimization (Nodal Analysis ) using Perform software
5.Optimization of Gas-Lift parameters (Injection rate and pressure) using Perform Software
6.Selection of wells candidates to hydraulic fracturing using
•Transient Pressure interpretation and analysis
•Near wellbore damage analysis and evaluation
•Production data, nodal analysis and well log analysis
•Correlation with near wells
•Predicting well performance after damage removal or reservoir stimulation
Hot Categories
Chemicals
Batteries
