Electrical & instrumentation Engineer
This is a candidate registered on Gulfoilandgas.com. To contact this candidate you need to purchase a subscription.
Education: 4
Experience: 4 years
Relocation: Yes - Domestically
Career Objective
Time served Electrical and Instrumentation Engineer having 3 plus years of experience in Oil and Refinery constructions, having deep knowledge in installation and inspection of both Electrical and Instrumentation equipments.
Professional Experience
Eletrical Experience
cable tray works on the pipe rack as per specification
underground cabling and cable pulling in cable tray.
Installation of panels, switch gear, MCC and switch rack.
Installation of low voltage motors and high voltage motor.
Installation of conduits, fitting supports.
Termination of panels, motors, JB, and MCC panels.
Motor solo run test , load test.
Motor MCC panel control circuit functional test.
Involve in testing and commissioning of electrical motor low voltage and high voltage system.
Interposing relay communication test between DCS and motor switch gear at MCC panel.
Instrumentation Experience:
Instrument installation.
Impulse tubing installation as per the hook up diagram.
Two methods of DCS communication used in this project. One is convectional another one is foundation field recently introduced method.
FF(Foundation field) junction box installation.
Calibration of transmitters like PIT,PDIT,FIT, LIT, TIT,AIT.
Calibration of valve like PV,FV,ZV,KV using FF and HARD communicator.
FF cable pulling, termination at JB side and instrument side.
Branch cable tray, cable pulling and termination as per specification
Loop checking :
The objective of Loop checking is to prove that the installed instrument function correctly, DCS configuration has been properly done as per requirement.
Transmitters Loops like Flow / Level / Pressure.
Control valve Loops like flow level pressure.
ZV loops ,On/ Off valve loops,
MOV loops, Switches loop,
Gas detectors, beacons,horns,
RTD/ Temperature loops,
Vibration loops, FFVMS loops, MCC loops
Eductation
Bachelor degree (B.E) in Electrical and Electronics Engg
ANNA University.
Year of passing: November 2005.
Percentage of marks: 68% (First class)
2. Diploma in Electrical and Electronics Engg:
Directorate of technical education, Tamil Nadu.
Year of passing: April 2001.
Percentage of marks: 84% (First class)
Certification
Auto cad : 2D drafting.
Network : CCNA course completed
Hot Categories
Chemicals
Batteries