experienced process engineer in environment concern & gas/crude oil treatment

get much more money and enlarge my technical experience in hydrocarbons products

-August 2001 to June 2003:Production engineer:
Review, analyse and optimize availability, reliability and efficiency of process treatment facilities in order to improve oil productivity level;

-Starting July 1st ,2003: Project process engineer:

2003-2004: following some production activities: condensate rerouting & gas availability study and implementation in the field, reduction of flared gas, Gas Dehydratiin unit performances recovery, then contribution in ASHTART revamping project contract mainly in scope of work preparation and technical bids evaluation;

2005-2006: feasibility studies phase for above project within SAIPEM ¡VITALY;

2006-2007:ASHTART revamping project FEED phase within same contractor SAIPEM:
Review, comment and approve all process deliverables: heat & material balance of existing and retained new options in ashtart field, PFD¡¦s , marked up PID¡¦s, relief and blow down system, assessment of existing facilities, de-bottelneck of some inadequate or under sized systems & equipment, optimization design study for new required process facilities, Material requisition for packages;
Since 2007: New packages requisition process and minor improvements preparation:
Contribution as per process comments in fuel gas compression package, LP gas compression package, gas lift compression package & other packages.
Contribution in HAZOP and SIL review sessions for the whole revamped ASHTART field;

Preparation of tender document for the supply of new packages, witness in a Tender floating committee, reply via tender bulletins to clarification request, starting the preparation of tenders evaluation method & technical evaluation reports,
2011:return back to operation as head of service looking after of surface production methods, official hydraulic test of pressure capacities, implementation of project tie-ins during if required some short shutdown, revamp of some existing units, follow up of production rate, replacement of flare tip's, renew the flare ignition system...,

From February 1998 to July 2001:safety enginer in Health & safety Institute for work (I.S.S.T) in Tunis:
-Technical witness of companies to assess chemical risk and suggest accordingly corrective actions to reduce exposure level inside work area;

1995-1997 : The National School of Engineering-Gabes (ENIG)
Degree in process Engineering
Graduated in June 1997.
1993 -1994 : Preparatory institute for engineers studies-Nabeul ;
1992 : Secondary school of EL HAMMA-GABES