mechanical engineer
This is a candidate registered on Gulfoilandgas.com. To contact this candidate you need to purchase a subscription.
Education: 4
Experience: 1 years
Relocation: Yes - Internationally
Career Objective
To get an opportunity in your well reputed organization where I can utilize my potential to its peak and quench my thirst for knowledge and experience
Professional Experience
•AES Lal pir thermal power plant Muzaffargarh (19 Nov.2007 to Date)
Currently I am working as a trainee engineer in a multinational American power plant AES Lal Pir with (365+362) MW capacity. During my training I have worked in the following areas:
1) BOP:
It consists of the pretreatment and demineralization system of water using clarifier, DMF, R.O system, cation exchanger, anion exchanger, decarbonator and polisher
2) Steam generator/boiler:
The largest Boiler in Pakistan with capacity 1200ton/hr includes decanting system of HFO, HFO pumping from PSO, air and gas system, water system, BCP System,FDF,GRF,Iry super heater, 2ry super heater, 3ry super heater, reheater,SAH and air preheater etc
3) Steam turbine:
Turbine being used in AES is “single reheat condensing tandem compound two cylinder double flow exhaust” with Condenser and air Extraction System, feed water system, service air compressors, hydrogen system, bearing cooling water system, stator coolant system, seal oil system etc.
• Ittehad chemicals Ltd.Kala shah kaku(10 Aug.2007 to 18Nov.2007)
Worked here as a trainee engineer and did supervision of central mechanical workshop which included maintenance of KSB pumps ETA-125/20, 50/16 etc, foundry shop &different machining processes (using DIN 2532)
Internships:
• Packages (pvt.)Ltd.Lahore ( Summer internship 2005) (4-weeks)
Worked in Consumer Products Department and was assigned the project “Waste reduction of toilet Roll machine”. I completed that project successfully which resulted in saving a large amount of capital.
•PEL (pvt.) Ltd.Lahore ( Summer internship 2006) (4-weeks)
Worked in switch gear section and was assigned the project “To reduce the MS sheet wastage and to enhance the process safety on shearing machine in panels welding shop” .I recommended the new design of safety cover of shearing machine which was accepted. Also worked in the production departments and got familiarized with the different processes and operations involved in the fabrication of LT, HT panels, transformers, refrigerators and air conditioners.
Eductation
Bachelors in Mechanical Engineering Cumulative percentage 81.11%
Fsc Pre-engineering: 2001 Garrison academy Kharian cantt. 75.09%
Matriculation: 1999 F.G Boys high school Kharian cantt. 84.71%
Hot Categories
Chemicals
Batteries