Electronic Engineer

Company who needs you.

I am working as a Electronic Engineer in Pepsi Cola Pakistan Beverages Limited from 26th April 2008(continue) .Where I am working on Blow mould machine (SBO 10) Sidel, Filler machine Labeler machine, Neck sleeve machine, SMI and Palletizer machine which are totally plc based and are of Sidel. Here I am utilizing my academic knowledge to solve the industrial problems in Electronics depart .I am working on Plc panels and I solve the problem occurring during production of the plant, and meanwhile working on new plant of Aquafina of Bulk bottle where I installed PLC, here I learn from the project engineer how to troubleshoot problems in industry and how to solve problems from PLC panels where different Electronics devices are automatically controlled.Here I learned to check the programm of PLC and to diagonose the fault occured in PLC.

Graduation :B.E (Electronics) In 2008 (“1st” DIV)
Mehran U.E.T Jamshoro Pakistan.

HSC:- Pre-Engineering In 2003 (“A” Grade)
B.I.S.E Sukkur.

SSC:- Science In 2001 (“A” Grade)
B.I.S.E Hyderabad.

I have done short courses and internships on control side which includes PLC and Controller programming. I have done microcontroller programming course and utilize it in my final year project which is hardware design of Robotic Arm totally based on controller programming.

I have done internships in Quetta Textile Mills Kotri on Robotic Arm, I observed how to troubleshoot the problem, and the total system was based on PLC and gain knowledge of industrial automation.

I am graduated from Mehran University of Engineering and Technology Jamshoro Pakistan in Electronics in April 2008.I am very enthusiastic and hardworking person who is always ready to accept challenges.

You will see from my attached that I intend to make my career in instruments and industrial automation side, I have been remained very active academic representative of the class, and this includes my hardware projects as listed in my resume during my academic session.

I have done short courses and internships on control side which includes PLC and Controller programming. I have done microcontroller programming course and utilize it in my final year project which is hardware design of Robotic Arm totally based on controller programming.

I have done internships in Quetta Textile Mills Kotri on Robotic Arm, I observed how to troubleshoot the problem, and the total system was based on PLC and gain knowledge of industrial automation.