Piping Stress Engineer

To be able to contribute the knowledge i have in Piping Stress engineering.

TOYO ENGINEERING AND CONSTRUCTION (OCT. 06 2007 – PRESENT)
KUALA LUMPUR MALAYSIA

POSITION: PIPING STRESS/ DESIGNER

• Pipe stress analysis of critical lines such as Compressor inlet and outlet piping.
• Analysis of critical lines such as steam lines, cold flares lines, and lines with PSV.
• Analysis of critical lines from Tower Reboiler to Reactor to Heat exchanger.
• Pipe support study for the analyzed system.
• Checking line list for other critical piping.
• Preparation of stress information for documentation.
• Stress Isometric production through AutoCAD 2008.
• Piping routing of lines from cooling water pumps to Cooling Tower.
• Piping routing of lines from vertical vessel going to pipe rack.
• Piping routing of lines such as steam, wastewater, nitrogen, etc.
• Preparation of piping information for civil such as dead loads and operating loads.
• Piping routing study for initial material take off.
• Materials take off of specialty items in P&ID.
• Materials take off of valves in P&ID.

FLUOR DANIEL, INC. (JULY 26, 2005 – OCT. 05, 2007)
FILINVEST ALABANG, MUNTINLUPA CITY

POSITION: PIPING STRESS ENGINEER
SAUDI KAYAN Project
(February 16, 2007 up to Present)
• Provide proper anchors and guides locations in lines lay in pipe rack.
• Compute thermal expansion of pipe to provide adequate line spacing.
• Provide structural group with support, guide and anchor loads.
• Decide for loop sizing and its location in pipe rack.

POSITION: PIPING STRESS ENGINEER
TESORO GER Project
(January 04, 2007 to February 16, 2007) – as PIPING DESIGNER
• Detailed Piping Design
• Route Pipes as per P&ID requirements and specifications.
• Apply specific project standards and instructions.
• Provide necessary pipe supports.
• Material take-off
• Produce isometric drawings.


POSITION: PIPING STRESS ENGINEER
TESORO GER Project
(August 2006 to January 2007)
• Analyzed system from pumps going to vertical vessel.
• Perform stress analysis of steam manifolds and tie-in connections.
• Assist Piping designer for supporting non stress lines.
• Analyzed high temperature lines such as flare headers and steam lines.


POSITION: JUNIOR STRESS ENGINEER
DOW OL2K Project
(April to August 2006)
• Assigned as a Junior Stress Engineer in DOW OL2K Project under direct supervision of Lead Stress Engineer.

Bachelor of Science in Mechanical Engineering
Batangas State University
Alangilan, Batangas City, Philippines

Licensed Mechanical Engineer
PRC Registered No. 65108

TRAININGS ACQUIRED:


Advance Stress Training

• CAESAR II CALC version 4.3 and 5.0
• Auto Pipe 2004 version 8.6


Basic Stress Training

Introduction to Pipe
• Simple Isometric and Ortho Projection
• Level Instruments
• Pressure Instruments
• Temperature Instruments
• Control Valve Manifolds
• Miscellaneous Field Supports
Micro station V7.1
PDS (Piping Modeling, Isogen)
Smart Plant Review
PDS Equipment Modeling
Material Manager