Instrument Eng. " Field

Seeking a position as Senior Instrumentation Engineer for maintenance /Construction phases, that will challenge my technical skills, improve my experience and provoke my analytical and problem prevention abilities.

Instrumentation engineer in Alexandria Petroleum Maintenance Company in Midor site (from 11/5/2004 up till now).
And the duties assigned to me as instrument engineer is to fulfill any Planned or Unplanned jobs.

Instrumentation engineer with ABB in GAPCO site (Port Saied), to install new DCS system with all interconnections and instrument field calibration (from 27/4/2008 to 30/5/2008).

Starting from troubleshooting to full calibration for level, flow, pressure and temperature transmitters and gages with various types and control valves with various types and shapes. Control valve, relief valve and orifice plates sizing by hand and using Fisher FirstVue Samson Valve Sizing Software.

Trained to use hart communicator, mA source, multifunction (source and measure), druck DPI 610 and Dead Weight tester (for pressure calibration and dp cells).
F&G troubleshooting and maintenance.
Maintenance for Ship loaders and loading arms systems in the offshore area in Alexandria port.

Alexandria Institute of Technology
Degree: Bachelor's of Electronics and Communications Engineering
Grade: Very good (Hall of honor), September 1997 – June 2002
Graduation Project:
Title: Power Line Communication.
Grade: Excellent.
Supervisor: Dr. Hossam Eldin Mostafa (Department of Electrical
Engineering Faculty of Engineering - Alexandria University).

Certified as having successfully completed 20 hours course on the Pneumatics systems awarded by Alexandria Petroleum Maintenance Co. (PETROMAINT).

Certified as having successfully completed training course in “Applied Instrumentation Engineering Technology” instructed by professionals from “The Northern Alberta Institute Of Technology” (NAIT) under supervision of EPI – MINSTRY OF PETROLEUM.

Trained to do transmitters selection for several cases.

Outlines in Bid format knowledge.

Certified as having successfully completed on site training in AQ & IQ RANGE commissioning and repair of ROTORK Mov’s.

Languages:

Arabic: Mother tongue.
English: Excellent.

Computer Skills:

Ms Office, Pascal programming, Graphics using C language, Internet surfing and Hardware maintenance .Interested in networking.

Skills:

Design, build, maintenance, and troubleshooting for electrical equipment .Handwork skills.