cswip 3.1 certified welding inspector
This is a candidate registered on Gulfoilandgas.com. To contact this candidate you need to purchase a subscription.
Education: 4
Experience: 1 years
Relocation: Yes - Internationally
Career Objective
to work in a challenging atmosphere where I can improve my technical skills in the area of Inspection & Quality control thereby improving quality standards of the organization in achieving the objectives and in turn lead me for an enhanced growth.
Professional Experience
company: sudha engineering services
Designation: QC Inspector
Duration: January 2008 to till date
responsibilities :
To review the material certificate chemical composition and the physical properties.Confirm the material against the material certificate.Check fit up, groove angle, type of groove, root gap and cleanliness of joint.Check/organize preheating and post weld heating.Check condition of welding equipment, current, voltage and polarity.Check proper supply of backing/purging gas if required.
Supervise and witnessing the welder qualification test as per welding standard procedures.Witnessing pre-heating and post- weld heat treatment as per the specification-requirement & as well as verification of heat treatment chart.Review of specification, referencing codes, standards and WPS.Verification and witness of non-destructive tests.Conduct inspection of all materials being used for welding activities, Prepare and submit quality report.
Witness for all testing activities with the client and third party and to get the final documentation after testing approved by them. Check individual weld passes, inter pass cleaning and temperature.Dimensional check of weld and preparation of stage inspection report.Perform welding inspection to ensure that all welding activities are properly executed.Check welding procedure (Essential and Non Essential variables) and individual welder qualification.
Preparation of NDT Interpretation reports as per ASME codes and client requirements. Ensure compliance on all stage and final inspection requirements as per approved Weld Plan, Drawings and procedures.
Attending repair according to RT film result and Interpretation of UT results.Calibration of all Non Destructive Testing equipments.Incoming material inspection and stock material reservations.
Preparation of QAP ,Developing WPS,Monitoring baking of welding consumables.
Preparation of Weld Plans and Coordination with TPA
Procedure Qualification, Welder Qualification
Eductation
B.E. Mechanical , Osmania University, (2004-2008), 1st division.
Intermediate, Board of Intermediate education, (2002-2004), 1st division.
ICSE, International school, 1st division.
Certification
CSWIP 3.1
certificate number:36460,
date of issue:19 december,2008
ddate of expiry:7 november 2013
Hot Categories
Chemicals
Batteries