Process Engineer
This is a candidate registered on Gulfoilandgas.com. To contact this candidate you need to purchase a subscription.
Education: 4
Experience: 5 years
Relocation: Yes - Internationally
Career Objective
Five years experience on the EPC Projects execution for Oil & Gas Fields. From Process Engineering disciplinary to site implementation in Engineering, Project Management, and activities from proposals state area up to projects completion.
Professional Experience
• Responsible for reviewing Preliminary Design and FEED documents of Process & Safety.
• Responsible for prepare and reviewing Process Deliverables from in-house or Engineering Sub-contractor, such as:
 Process Flow Diagram (PFD)
 Utility Flow Diagram (UFD)
 Heat and Material Balance (HMB)
 Piping and Instrumentation Diagram (P&ID)
 Process Data Sheet
 Equipment Sizing (Pressure Vessel, Atmospheric Tank and Pump)
 Line Sizing
 SAFE Chart
 Cause and Effect Chart
 Utilities Calculation
• Over-Pressure Protection System (OPPS) Study
 Prepare Scope of Work
 Prepare technical Bid Evaluation
 Review OPPS Deliverables from Specialist Sub-Contractor; i.e. Over-Pressure Scenario, Over-Pressure Protection System Dynamic Simulation, HIPPS SIL Assessment Report and Final Report of Over-Pressure Protection System
 Prepare Verification for Quantitative Calculation of Over-Pressure Protection System
• Review Safety Deliverables from Engineering Sub-Contractor
 Emission Register
 Fire Water Demand
 Hydraulic Calculation
 Flare Radiation Analysis
 Safety Study (HAZID, HAZOP, ENVID, SIL, QRA, DORA, etc)
 Safety Layout, Hazardous Layout, F&G Layout
 Safety Equipment Data Sheet
• Formal HSE Study
 Prepare Scope of Work
 Participate on 1st and 2nd Session of HAZID, ENVID, HAZOP and SIL
 Review Formal HSE Study Deliverables from Specialist Sub-Contractor; i.e. QRA, FRA, EOS, DORA, ESSA, ESSRA, ETRERA
• Provide and verify Process Data for other Engineering disciplines, especially for Instrument and Mechanical
• Prepare Technical Bid Evaluation for Safety Equipments
• Assist for preparing Scope of Work for Hook-Up Activities
• Prepare and assist Work Plan, marked-up P&ID , Check List & Inspection Test Record and Sub-System dossiers for Onshore Pre-Commissioning/Commissioning Activities
• Prepare As-Built P&ID
• Developing Start-up Philosophy
• Prepare Plant Operating Procedure Manual (POPM) for Process and Utility System
Eductation
Bachelor Degree from Bung Hatta University, Faculty of Technology Industry, majoring in Chemical Engineering, Indonesia
Hot Categories
Chemicals
Batteries
