Geotechnical Engineer Assistance

To obtain a position as an Geotechnical Engineer Interests Ground Investigation Foundation Engineering Deep Foundation and Retaining Structures Design Soil Improvement & Soil Reinforcing Site Characterization Landfill and Embankment Design

• Geotechnical Engineer, Tehran, Iran, June 2008 – present
SANO Consulting Engineers
Duties:
Planning, Execution and Report Writing of geotechnical investigation projects
• Geotechnical Engineer, Tehran, Iran, September 2003 – May 2008
DaryaKhakPay: Marine, Geotechnical and Structural Consulting Engineers
Duties:
 Preparation of field and laboratorial tests instructions for geotechnical investigation projects
 Analysis of soil data collected from field and laboratorial tests to interpret soil parameters
 Presentation of field and laboratorial tests results
 Giving geotechnical engineering recommendations (Bearing capacity, Soil replacement, Subgrade reaction etc)
 Settlement calculations
 Liquefaction and slope stability assessment
 Training junior engineers in the company
 Cost estimation of geotechnical investigation studies
• Civil Engineer, Tehran, Iran, April 2001 – September 2003
Soils Engineering Services Consulting Engineers (SES)
Duties:
 Conducting of soil mechanics laboratorial testing (conducting tests on samples of soil, rock, asphalt and water)
 Analysis of soil data collected from field and laboratorial tests to interpret soil parameters and preparing subsurface profile of soils
 Preparation of drawings, charts and other relevant engineering items
 Working with software packages provided by the company to assist senior engineers to prepare geotechnical reports
 Assisting senior engineers in preparation of geotechnical reports

B.E., Civil Engineering, January 2001
Amirkabir University of Technology, Tehran, Iran

 Primavera software Certificate, Tehran Institute of Technology, May 2005

Familiar and worked with the following computer software and programs:
 MS Office (MS Word, MS Excel, Power Point)
 ETABS, SAP, AUTOCAD
 PLAXIS, LPILE, ALLPILE and SLIDE