YOKOGAWA DCS Automatic control system and instrumentation engineer
This is a candidate registered on Gulfoilandgas.com. To contact this candidate you need to purchase a subscription.
Education: 4
Experience: 4 years
Relocation: Yes - Internationally
Career Objective
Basic and detailed engineering Design Of Automatic Control and Instrumentation and Installation, Maintenance & Wiring The control devices and sensors and DCS Sys.
Professional Experience
From 10/2009 up to now GUPCO NORTH SHADWAN NEAR SHORELINE PROJECT
Client: GUPCO
Position: System Engineer
Duties:
• Responsible for the project engineering activities which are done in GIZA, and issuing of project Documentation, managing the Factory Acceptance Tests, and site activities during commissioning and startup.
• Engineering, installation, Pre-commissioning, commissioning and start up of the DCS system CENTUM CS3000
• Commissioning and start up the MODBUS network with the subsystems package
HP PROJECT
Client: BURULLUS GAS COMPANY IN IDKU
Position: System Engineer
Duties:
• Pre-commissioning, commissioning and start up of the DCS system CENTUM CS3000
• Commissioning FIELDBUS devices using PRM (Plant Resource Manager)
• Commissioning and start up the MODBUS network with the subsystems package
BOOSTER COMPRESSOR PROJECT
Client: RASHEED Oil & GAS COMPANY in Alex.
Position: System Engineer
Duties:
• Responsible for the project engineering activities which are done in GIZA, managing the Factory Acceptance Tests, and site activities during commissioning and startup.
• Engineering, installation, Pre-commissioning, commissioning and start up of the DCS system CENTUM CS3000
• Commissioning FIELDBUS devices using PRM (Plant Resource Manager)
• Commissioning and start up the MODBUS network with the subsystems package
NEW TSA PROJECT
Client: BURULLUS GAS COMPANY IN IDKU
Position: System Engineer
Duties:
• Responsible for the project engineering activities which are done in GIZA, managing the Factory Acceptance Tests, and site activities during commissioning and startup.
• Engineering, installation, Pre-commissioning, commissioning and start up of the DCS system CENTUM CS3000
• Commissioning FIELDBUS devices using PRM (Plant Resource Manager)
• Commissioning and start up the MODBUS network with the subsystems package
1000 ton ammonium nitrate plant
Client Al-Nasr for fertilizers and chemical industries
Position: ICS System Engineer
Duties:
• Maintenance for DCS, ESD and FGS systems (CENTUM CS3000) and PRM.
• Responsible for:
1. Analyzing and troubleshooting for the systems
2. On job training to Client staff
3. Planning and accomplishing the system Preventive maintenance according to Yokogawa procedure.
Eductation
Ø B.Sc. Of Electronics Engineering
Faculty of Electronics Engineering May 2004
Hot Categories
Chemicals
Batteries