Hussamuddin_CV
This is a candidate registered on Gulfoilandgas.com. To contact this candidate you need to purchase a subscription.
Education: 5
Experience: 1 years
Relocation: Yes - Internationally
Career Objective
To work in congenial, high energy and professional set up and therefore grow intellectually. To prove my skills involving challenging projects with forward-looking professionals.
Professional Experience
Working at Mumbai High Offshore Platform(Oil and Natural Gas Corporation) as Assistant Executive Engineer (Production)
Hands on Experience in:
1. Offshore platforms
2. Subsea well operations
3. Gas Lift Operations
4. Water Injection
5. Well Testing
6. Three phase Separators (High pressure and Low pressure)
7. Hot Oil system
8. Waste heat recovery units
9. Process Gas Compressors
10. Low pressure Gas Compressors
11. Air compressors
12. Fuel gas conditioning skid
13. Chemical Injection systems
14. Instrument Air system
15. Nitrogen Generator
16. Produced water treatment system
17. Gas Dehydration Unit
18. Glycol (TEG) Regeneration
19. Gas Sweetening unit
20. Amine (MEA) Regeneration
21. Fire Water Pumps and Gas detector systems
22. Oil Corrosion inhibitors
23. Gas Corrosion inhibitors
24. Control Valves, safety valves, Blow down valves, Deluge valves, MOVs etc
25. Permit to Work system.
26. Knock out drums
27. Closed Drain System
28. Crude Oil Transfer pumps, Low shear LP produced water pumps, Floatation cell pumps, etc
Undergone Practical training at Oil and Natural Gas Corporation Limited (May 11-July 11)
• Regional Geoscience Laboratory
• Cauvery Asset (Group Gathering station,Work Over Rigs,Cementing)
Eductation
M.Tech in Petroleum Engineering from Indian Institute of Technology Madras, Chennai with 84.2% (2012)
B.Tech in Chemical Engineering from National Institute of Technology Calicut, Calicut with 71.4% (2010)
XII Narayana Junior College, Hyderabad with 92.3%
Certification
TRAINING ATTENDED
1) Survival at sea
2) First Aid
3) Fire Fighting
4) H2S safety
5) Helicopter Underwater with Emergency Breathing System
• Member of SPE , IChE, ASME
Additional Information
PROJECTS
• Enhanced Oil Recovery using CO2 flooding (July 2011-June 2012)
• Effect of various inlet conditions of CO2 on EOR
• To carried out PVT analysis for black oil using CMG Winprop
• To study effect of water flooding in a well sorted consolidated sandstone on oil recovery and flow rate by using CMG software
• To study the effect of CO2 flooding on oil recovery
• Hydrogen production from Organic wastes (July 2009-April 2010)
• Studied the hydrogen production efficiency from micro organisms (E.coli and Hafnia Alvie)
• Influence and Simulation Model of Operational Parameters on Hydrogen production
• Design of Rotary Dryer for the drying of sodium sulfate crystals (December2008- May 2009)
• Selection of the required dryer (i.e. rotary dryer) that best suits the scenario.
• Design of the rotary dryer as per the given conditions Analyzed
Hot Categories
Chemicals
Batteries
