Electrical Maintenance Engineer

I am seeking an opportunity to utilize existing skills and to experience new skills by working with talented and passionate people from different disciplines and to obtain a position as Electrical Engineer that will utilize my passion

from 6\2006 – till now.
Working as maintenance engineer in Al Kharafi National


Maintenance and repair works for Electrical and Control devices with accessories at ministry of electricity &water in different areas of the State of Kuwait, employed as a site Primarily responsible for executing, leading ,supervising and coordinating electrical maintenance plans for MEW maintenance of telemetry ,electrical and control equipments pumping station ,water reservoirs ,water towers and water distribution networks repairing and testing (starter panels -protection relay for over current –earth fault –dry runing-thermal over load - electrical panel for low &medium voltage- (step down Transformer –CB- different types(air CB-oil CB-air blast CB - VACUUM CB-SF6 CB – pump motors different rating “friction HP to 2MW “power &control circuit –- motor operating valve - lighting system in all Water sectors
- to prepare as built drawings for modified work
- to improve and develop the electrical systems and control circuits
- to lead and supervise construction works
- to submit ,approve interim measurements and evaluation from clients
- to do cost estimates and technical studies for other projects

Since6\ 2003 - 6\2006.

Working as electrical engineer in El-Kureimat Thermal Power Plant (2X627) MW
Responsible for step up transformer (3x1ph -23/500kv)high voltage switch gear 500 KV auto transformer 500/220 KV -Switch gear 220 KV - start up transformer (220/6.6KV)-unit auxiliary transformer 23/6.6 KV-low voltage & medium voltage-Control & protection for motor in power station

2000-2003

Maasara for Engineering Industries Co. (Ex. 45 Factory). Working as maintenance engineer in the Electrical maintenance department - Responsible for step down sub station 16 MW& Maintenance and repairing production line- Maintenance Of Presses (from 2 ton to 900 ton) -Plastic Injection Machines -Automatic lathes( 6 spindles) -Maintain and repair old conventional relays control panels and new control panels –based on PLC. Dealing with the following types of PLC & speed drive soft start Inverter systems:, Allen Bradley & Siemens (Step7) , troubleshooting faults .

1994 - 1999
College::Cairo Faculty of Engineering, Cairo University
Department: Electrical power and Machines Engineering.
Graduation grade: Good (70.38%) as a total grade.
Graduation Project
Title "Automatic control"
Description - Development control system for ship unloader
(Develop a PLC -based control system for ship unloader)
Project Grade: very good

Training course (programmable logic control PLC)
Basic course on (logic control “PLC")
Training course on transformer tap changer
training on –Power Electronics &sensor technology (GTZ) controlling AC machine speed VIA Siemens micro master 440 frequency with standard level programming & testing the characteristic proximity sensors
Training course on (frequency converter)
Training course on (operation of combined cycle power stations
Training on (maintenance &operation electrical machine equipment
trained on studying sub_ station, generators,transformer, power factor correction panels ,speed drives and connection of MCC with PLC.
trained on studying feeder, generators ,transformers,electrical motors,C.B and, GIS power station500kV,220kVstudying generators and transformer protection circuit studying medium and low voltage loads and measuring equipment.