QA/QC Inspector/ Engineer (Mechanical)
This is a candidate registered on Gulfoilandgas.com. To contact this candidate you need to purchase a subscription.
Education: 3
Experience: 8 years
Relocation: Yes - Internationally
Career Objective
Challenging project opportunity where I can contribute my talents to a successful team and to further my knowledge in mechanical engineering field for development of organization and self.
Professional Experience
Mechanical Engineer with more than seven years experience in QA/QC, including Construction of Process Piping Plants, & Pipelines, Shut down jobs , Non Destructive and Destructive Testing, Equipments inspection and calibration, holding position such as Welding Inspector/QC Inspector-Mechanical. I am having good Knowledge in Welding Metallurgy, Materials, Raw Material Inspections, Heat Treatments, Destructive and Non destructive Testing, QMS Audits, Codes & Standards like ASME, ASTM, EN etc.
Eductation
Professional Qualification
1. TWI- CSWIP 3.1 CERTIFIED (CERTIFICATE NO. 49067)
2. D.M.E.(Mechanical Engineering) with 81.4 % (Distinction) from M.I.T. under “WEST BENGAL STATE COUNCIL OF TECHNICAL EDUCATION” in 2003.
3. C.W.I.(Certified Welding Inspector) from “WELDING RESEARCH INSTITUTE” BHEL, TRICHY in March 2008.
4. Approved Quality Control Inspector (Welding) from P.D.O. (Petroleum Development of Oman)
5. Certification in NDT (ASNT level-II) RT, UT, PT & MPT.
Educational Qualification .
B Sc. From “BURDWAN UNIVERSITY” under “WEST BENGAL STATE GOVT.” in 1999.
Certification
1. TWI- CSWIP 3.1 CERTIFIED (CERTIFICATE NO. 49067)
2. D.M.E.(Mechanical Engineering) with 81.4 % (Distinction) from M.I.T. under “WEST BENGAL STATE COUNCIL OF TECHNICAL EDUCATION” in 2003.
3. C.W.I.(Certified Welding Inspector) from “WELDING RESEARCH INSTITUTE” BHEL, TRICHY in March 2008.
4. Approved Quality Control Inspector (Welding) from P.D.O. (Petroleum Development of Oman)
5. Certification in NDT (ASNT level-II) RT, UT, PT & MPT.
Educational Qualification
B Sc. From “BURDWAN UNIVERSITY” under “WEST BENGAL STATE GOVT.” in 1999.
Additional Information
1. Conducting & monitoring of Procedure Qualification Test (PQR) and maintaining record.
2. Conducting & monitoring of Welder Qualification Test (WQT) and maintaining record.
3. Inspection of Incoming material & welding Consumable.
4. Verification of Fit-up & Visual Inspection of weld.
5. Monitoring of preheat and interpass temperature & PWHT.
6. Monitoring of welder continuous performance and record it.
7. Dimensional checking, Review AFC Drawing & As built drawing.
8. Witnessing of Hardness testing & PMI testing.
9. Witness of Pneumatic & Hydrostatic Testing.
10. Preparation of Weld History sheet of Weld Joints.
11. Checking over all status & weld joints offering to the NDT agency.
12. Review of weld radiography film.
13. Welder repair percentage analysis and tool box talks for welders to control repair
percentage.
14. Ensure Flange Tightening and Torquing As per Requirements.
15. Witness of MPT, PT & UT.
16. Review of weld radiography film.
17. Preparation of all applicable documents (Test pack).
Hot Categories
Chemicals
Batteries
