Pipe Chargehand
This is a candidate registered on Gulfoilandgas.com. To contact this candidate you need to purchase a subscription.
Education: 1
Experience: 8 years
Relocation: Yes - Internationally
Career Objective
Looking for a job as Pipe Chargehand.
Professional Experience
Cut and bore holes in structures, such as bulkheads, decks, walls, and mains, prior to pipe installation, using hand and power tools.
Cut, thread, and hammer pipe to specifications, using tools such as saws, cutting torches, and pipe threaders and benders.
Inspect, examine, and test installed systems and pipe lines, using pressure gauge, hydrostatic testing, observation, or other methods.
Lay out full scale drawings of pipe systems, supports, and related equipment, following blueprints.
Measure and mark pipes for cutting and threading.
Modify, clean, and maintain pipe systems, units, fittings, and related machines and equipment, following specifications and using hand and power tools.
Plan pipe system layout, installation, or repair according to specifications.
Select pipe sizes and types and related materials, such as supports, hangers, and hydraulic cylinders, according to specifications.
Inspect work sites for obstructions and to ensure that holes will not cause structural weakness.
Remove and replace worn components.
Turn valves to shut off steam, water, or other gases or liquids from pipe sections, using valve keys or wrenches.
Assemble and secure pipes, tubes, fittings, and related equipment, according to specifications, by welding, brazing, cementing, soldering, and threading joints.
Attach pipes to walls, structures and fixtures, such as radiators or tanks, using brackets, clamps, tools or welding equipment.
Supervision and training of employees i.e. apprentices
The daily running of a fabrication facility
Eductation
Pipe Fabrication from CCC, Qatar in the year 2011
Certification
Leading a Commissioning task team
Hazard Identification
Productivity Through Planning & Organizing
HSSE & Leadership
Training the Trainer
Quality Control
Cultural Awarness
Incident and Injury Supervision
Introduction to FSI, PTW & TSTI
Electrical Safety Rules
Authorized Gas Testing
Mechanical Joint Integrity
Hydrogen Sulphide Awareness
Emergency Response
Lifting & Rigging Awarness
Defensive Driving Refresher
Confined Space Entry
Managing Pressure & Leak Testing
Non – Destructive Examination
Working at Height
Hand Safety & Manual Handling
Additional Information
Completed The Leadership and Supervisor Training Programme from the Institute of Leadership & Management
Hot Categories
Chemicals
Batteries
