Process engineer

I have over 8 years of experience in the oil &gas industry which covers process design . Notably, I possess the skills of preparing process datasheets, PFD, P&ID, hydraulic calculation, process simulating with Hysys, Promax, and Flarenet.

March 20th 2008 - Present IRAN INTERNATIONAL ENGINEERING CO.(IRITEC)
[Process design Engineer ]
[ Kharg Island Gas Gathering and NGL Recovery Project]

Check & regenerate all technical documents which are prepared during Basic& Detail Design by Sub-contractors of project mentioned as below

1. Process data sheets
2. Material Requisition,
3. Technical Bid of Evaluation
4. Process Simulation (using HYSYS.)
5. Line, Control Valve and Pump Hydraulic Calculations
6. Relief Load Calculation & PSV Sizing (API 520, 521 & 526)
7. Flare Network Design and Calculations (API 521)
8. Depressurizing Calculation and Low Temperature Studies (API 521)
9. Design and Generation of BFD, UFD, PFD & P&ID
10. Utility consumption list
11. Preparing utility Material balance.
12. Cause and Effect Diagram Preparation
13. Major Equipment Sizing and Datasheet Preparation for Equipment and Auxiliary
14. HAZOP participant as IRITEC representative for endorsement & feed updating of NGL Recovery Project in SOFREGAZ company office (Paris)
15. Other Process related works.
16. Modeling plant with PHAST/PHAST RISK for QRA study

As Process Engineer in Kharg Island Gas Gathering and NGL Recovery Project I have been involved at Utility & off sites and NGL /AGR/SRU/TGTU Systems
Units.December 20th 2004- March 20th 2008 MAPNA BOILER CONSULTING ENG.


Design & generate all technical documents which are listed as below:
1. Design and Preparing of Heat Recovery Steam Generator (HRSG)
2. P&IDs for Combined Cycle Power plants and Utility Steam Plants.
3. Pipe Sizing Calculation
4. Hydraulic calculation for pipelines and pump
5. Preparing of P OS for, Boiler Feed Water Pump,
6. Preparing of P OS for Integral and External type Deaerator, Chemical Dosing System,
7. Preparing of P OS for Steam and Water Sampling System
8. Thermal Design of Deaerator, Flash Tank, and Blow down Tank.
9. Plant Lay out (Plot Plan) preparation
10. Member of Technical Proposal Preparing Team
11. Boiler water conditioning


As Process Engineer in Combined cycles I have been involved specifically at below mentioned projects:

1997–2001 Amir Kabir University of Technology TEHRAN
[ Degree/Major ]
B.S. degree in chemical engineering Graduated Date: September 30st 2001.

Professional in reading writing and speaking of British and US English
(IELTS 6, GENERAL).(reading:6 ,writing:6.5 ,listening:5.5,speaking:6.)
Software & Training :
Auto CAD.
Word, Excel, Adobe Acrobat
Process Simulation, Hysys Software. June 2003, Tehran University
Process Simulation, Promax .Software., IRITEC
Process Simulation .Flare Simulation with FLARE Net Software. Oct. 2008, IRITEC.
Safty Simulation, PHAST/PHAST RISK Software.
Process Simulation, Thermo flow Software.(Combined Cycle Power plant CCPP)Sep. 2009, IRITEC