construction engineer onshore and offshore
This is a candidate registered on Gulfoilandgas.com. To contact this candidate you need to purchase a subscription.
Education: 4
Experience: 8 years
Relocation: Yes - Internationally
Career Objective
•I have 8 years experience execution the work of people who are involved in fabricating, assembling, installing, and maintaining piping, fixtures, and equipment for gas, steam and oil
Professional Experience
Responsibility and nature of work:
Carry out site survey to verify the existing conditions.
Verify availability and adequacy of all required utilities and services.
Retrieve and verify accuracy of all relevant existing drawings and documents to the work.
Generate site survey report.
Responsible for piping fabrication, installation and testing.
Carry out the pre-fabrication of piping spools at workshop in order to minimize hot work at site as per the approved drawings.
Provide tags with spools numbers for all the fabricated piping spools for easy identification while erection.
Fabrication of all pipe spools shall conform to the requirements of Qatar gas standards & specifications.
Responsible for proper identification of correct material during fabrication item no will be provided as per drawings.
Mobilize the indirect and direct manpower and tools and tackles required.
Ensure availability all the piping fittings, gaskets stud bolts & nuts.
Carry out the torqueing for the entire tie in as per approved procedure.
Operation of X-mas Tree Gate valves, Swab/crown, upper master, lower master, wing valves (operating & closing), surface safety valve, adjustable choke valve, and SSV/shut down valve SDV.
Choke Manifold, upstream, by-pass positive choke valve, and Adjustable choke valve and down changing of chokes.
Oil & Gas pipe manifold-port side or starboard side valves.
Knowledge on flow lines, work of separator, conditions of test, production separator, 3 phase (Gas, oil & water) separator, Pressure Control Valve PCV, oil level controller, gas pressure controller, changing of orifice plates, taking separator reading, flowing well fluid through separator, bypassing opening and closing of manual low torque valves
Eductation
Course Completed
Bachelor of mechanical engineering first class 2004
Diploma in mechanical engineering first class with honour’s 2001
H2S and Gas Test
Sea Survival
HUET
Certification
Course Completed
Bachelor of mechanical engineering first class 2004
Diploma in mechanical engineering first class with honour’s 2001
H2S and Gas Test
Sea Survival
HUET
Hot Categories
Chemicals
Batteries
