Process Engineer
This is a candidate registered on Gulfoilandgas.com. To contact this candidate you need to purchase a subscription.
Education: 4
Experience: 4 years
Relocation: Yes - Internationally
Career Objective
To obtain a position as a process engineer where my skills, experience and qualifications can be fully utilized to our mutual benefit.
Professional Experience
A. Client: Total Exploration and Production Limited
Project: Odudu Expedition Turbine Meter isolation
Objective: To carry out study and modification of lines to expedition turbine meters and provision of on-line provers in series whenever turbine meter goes for quarterly maintenance.
Designation: Process Engineer/Designer
Duties:
Generation of Demolition and Construction Drawings to be used for construction
Developed a Process Report to highlight specific problems associated with each platform and proffered solutions
B. Client: Addax Petroleum
Project: Adanga Gas Lift Conceptual Studies
Objective: To carry out a conceptual design study for the new Adanga Lift Gas Compression Platform that will be bridge-linked to the existing Adanga Complex.
Designation: Process Engineer
Duties:
Determined the number of stages of compression for different cases/scenarios involved
Performed Hysys modeling to generate properties of the fluid streams on the Heat & Material Balance
Equipment List Generation
Carried out preliminary sizing of Separators and Scrubbers to determine their sizes
Performed Line Sizing Calculations for Single and Double Phase Piping Systems
Development of Process Equipment list
Drafting of Equipment Layout drawings
Generation of Process Design basis
C. Client: Addax Petroleum
Project: Antan Wellhead Platform Design
Designation: Process Engineer/Designer
Drafting of Platform Layout and Elevation drawings
Generation of Equipment List
D. Client: Pan-Ocean Oil Corporation.
Project: Ovade-Ogharefe Gas Utilization Project
Objective: To carry out the Front End Engineering Design of increasing the Phase 1 capacity of the Ovade-Ogharafe, which is 100 MMSCFD, to 200 MMSCFD.
Designation: Process Engineer
Duties:
Process Flow Simulation using HYSYS to generate properties of the fluid streams on the Heat & Material Balance
Performed Pump and Vessel (Separators) sizing calculations
Generation of Process Datasheet
Performed Line sizing Calculations for Single and Double Phase Piping Systems
Process Drafting of PFDs and PIDs
Line List Generation
Eductation
2000 – 2007 Obafemi Awolowo University Ile-Ife, Nigeria
B.Sc, Chemical Engineering (Second Class Division)
1993 – 1999 St. Patrick’s Grammar School Bashorun, Ibadan
Senior School Certificate Examination
Hot Categories
Chemicals
Batteries