QC INSPECTOR (CSWIP 3.1, BGAS -2)

Project management including inspection, site execution and coordination in construction. 2. Assisted & submitted daily reports to QC manager.

. Monitoring welding activities as per WPS .
2. Visual inspection of completed welds as per code requirements.
3. Monitor preheating, PWHT, post heating, hardness checking, PMI checking, hydro testing of piping. 4. Checked to ensure equpiment is caliberated before starting job.
4. Witness in alignment of shaft and coupling of rotating equipment and balancing of FD fan.
5. Painting environmental conditions were checked and compared to specification and recorded.
6. Surface profile checked after blasting with relevant standard by testex tape, comparator.
7. WFT, DFT of paint application was taken during each stage of inspection.
Weather conditions were checked and compared to specification and recorded.
2. Surface profile checked after blasting with relevant standard by testex tape, comparator.
3. FBE liquid joint coating for buried service piping and heat shrink sleeves, tape wrapping etc. 4. WFT, DFT measuring, holiday test and final inspection as per client standards.

B.Tech Mechanical Engineering with a CGPA of 6.8 from Kerala University, India. Plus two with 85% from Kerala higher secondary board, India.
SSLC with 94% from Kerala state board, India.

CSWIP 3.1 welding inspector level – II (cert no : 102865, expiry : 16/06/2020)
 BGAS – CSWIP painting inspector grade – 2 (cust. ID : 687422, expiry : 20/10/2020)  ASNT Level II Ultrasonic Testing (UT)
 ASNT Level II Radiographic Testing (RT)
 ASNT Level II Magnetic Particle Testing (MPT)
 ASNT Level II Dye Penetrate Testing (DPT)