Senior rotating equipment and condition monitoring mechanical engineer
This is a candidate registered on Gulfoilandgas.com. To contact this candidate you need to purchase a subscription.
Education: 5
Experience: 8 years
Relocation: Yes - Internationally
Career Objective
rotating equipment and condition monitoring mechanical engineer
Professional Experience
Achieving full engineering support to plant maintenance management in different maintenance techniques corrective maintenance, preventive PM & Predictive maintenance PdM according schedule required for running equipment and follow up work order progress.
Establishing and define condition monitoring strategy and related physical asset management.
Execute online and offline vibration analysis, ultrasound, thermography, alignment and lube oil analysis as set out by the condition monitoring program and issue technical and investigation reports as required in addition to regular preparation of condition monitoring plan and monthly reports for the rotating equipment (e.g., turbines, Pumps, Gearboxes, blowers, fans and compressors).
Responsible for technical aspects of asset care, reliability and integrity condition monitoring survey of rotating equipment and carry out analysis.
Preparing materials required for PM and overhaul works requirements according inspections.
Overhauls, repair and Start-up in planned or unplanned maintenance for the following equipment:-
Several air compressors types (Air-Dyne, Concord, Gardner Denver, Ingersoll Rand , and Atlas-Copco).
Reciprocating Gas compressor Dresser -Rand (D-R Compressors 6HOS-4 throw) driven by Waukesha gas engine (Waukesha L7042GSI & L5790GSI gas engine).
Reciprocating Gas compressor Ajax (DPC-800 models) integrated with gas engine.
Pumping unite (adjustment inspection maintenance correction)
Centrifugal pumps several type; (ALLWEILER &PROMINENT (multi stage - double suction - vertical design - open impeller)).
Positive displacement pumps several type;
(LIEWA & WILDEN reciprocating type pump (piston plunger diaphragm).
Reciprocating (DUPLEX TRIPLEX) plunger type.
GEAR Pump.
Knows the Company health, safety and environmental policy, procedures, regulations and objectives.
Eductation
PhDs Degree in condition monitoring and fault analysis on gearbox (In Progress).
Pre-PhD's Degree. (July 2015 GPA grade A).
Master in Heat recovery through Enhancing the performance of the VCR unit". (November, 2012).
Pre-Master of Mechanical Engineering. (July, 2010 GPA grade A ).
B.Sc. OF Power Mechanics Engineering, Assuit University. (June, 2009).
Certification
Certified from international vibration analysis institute (Mobius institute) Cat II).
Certifications in Soft Skills Training
Additional Information
Training Courses:
Vibration Analysis, Vibration institute, USA, Category III (Course Attendance & Certification( in progress)
Vb8 Comm test vibration device data gathering device in vibration analysis.
Vibration Protection Systems for rotating machines.
Thermal Camera and heat gun methods of follow temperature gradient (using device Model /EX50).
Ultrasound techniques in condition monitoring for mechanical components, air system leakage and electrical problems detection (using device Model /UE9000).
Laser Alignment Techniques (using fixture laser devices for shaft and pulley alignment).
Maintenance Strategies.
Trained to use bore-scope technology.
Gas Engine Operation and Maintenance.
Gas Compressors Operation and Maintenance.
Pumps Calcifications, Testing, Operation, and Maintenance.
Reciprocating Air Compressors Calcifications, Operation, and Maintenance.
Time Management.
Planning.
Team work.
Crisis Management.
Hot Categories
Chemicals
Batteries