Process Engineer, Research and development, Commissioning engineer

Develop a deep understanding, improve and optimization of petrochemical process

[2013-2016] Iran Petrochemical Research & Technology Co. (Research and Development-Investigating the effect of different parameters and conditions on the productivity of VCM suspension polymerization process and the properties of PVC product experimentally and theoretically, decreasing the polymerization time up to 50% using continuous initiator dosage technique in a semi-industrial pilot and also modeling this process)
[2019-2019] Assad chemistry Sepahan Co. (R&D and Production Manager - Startup of a new methyl acetate production unit and increasing its purity from 90 to 96%).
[2019-2022] Regal Petrochemical Co. (Head of Process Engineer and Energy manager - Optimizing of gas-phase propylene polymerization process by reducing the flaring more than 50% and increasing the conversion about 10% - Simulation and optimization of separation and purification unit).
[2020-2022] Arvand Petrochemical Co. (R&D advisor – Preparation an application software for modeling, simulation and optimization of SPVC polymerization reactors and provide proper techniques for VCM polymerization and VCM recovery units).
[2024-Now] Gachsaran Petrochemical Co. (Pre-commissioning and commissioning of olefin unit, review and modify of documents i.e. procedures, equipment data sheet and mechanical drawing, logic, control philosophy, set point and alarm lists, and supervision on these).
[2024-Now] Gachsaran Petrochemical Co. (Process Engineer- Monitoring, control and improvement of olefin and utility units).

2012-2016 PhD in Chemical Engineering (Petrochemical Process)
Isfahan University of Technology, Isfahan, Iran
Thesis: Continuous dosage of initiator into the Vinyl Chloride suspension polymerization and its effect on reaction time and product properties (Experimental and modeling). The Iran Petrochemical Research & Technology Co. financially supported this research (Contract no.:0870429202).

2009-2011 MSc in Chemical Engineering
University of Kurdistan, Sanandaj, Iran.
Thesis: Modeling and optimization of remediation process for oil-contaminated soils by composting process. The National Iranian Oil Products Distribution Co. financially supported this research (Contract no.:16/900518).

2003-2007 BSc in Chemical Engineering (Gas process)
Islamic Azad University, Gachsaran branch, Gachsaran, Iran.
Thesis: Simulation of heat transfer in heater systems using ANSYS software.