| Reference | SDG0139P19/06 |
| Date | 2/3/2019 |
| Location | Asia |
| Scope | The company announces its need for supply & Installation Commissioning of High Pr. The instruments to be supplied are as follows: Qty=01 of 1.High pressure Light Weight Lubricator Assembly(10,000 Psig rating) for both 0.092" and 0.108" Wireline Operation comprises of the followings: a) BOP: (i) Working Pressure 10,000 Psig, I.D. 3(Three)inches single ram with the provision for both manual and hydraulic operation (ii) Connection: Bottom: Flange type with working pressure of 10,000 Psig, having ring gasket B X 153 to suit with the top of Christmas tree of size 2-9/16 inch x 10,000 Psig Top: Quick union BOX to connect with lubricator riser bottom union PIN. Inner seals of the rams shall be compatible/ provisioned for both wirelines of size 0.082 inch and 0.092 inch. (iii) Weight: The weight of the BOP should not be more than 90 kg. b) Hand Pump for BOP operation Suitable hydraulic hand pump shall be supplied for BOP hydraulic operation along with 100 feet hose, complete with end connection. c) Lubricator Riser Lubricator Riser should be comprised of 3 sections (i) Lower Section: I.D : 3 inches ; Length : 8 feet, to be provided with 1/2 inch NPT port along with suitable bleed-off valve ; Weight : The weight of the lubricator riser should not be more than 55 kg. (ii) Middle Section: I.D : 3 inches ; Length : 8 feet ; Weight : The weight of the lubricator riser should not be more than 50 kg. (iii) Top Section: I.D : 3 inches ; Length : 4 feet ; Weight : The weight of the lubricator riser should not be more than 30 kg (iv) Connection: Quick union connection PIN down and BOX up for each section of lubricator riser Bottom : Threaded quick union PIN to suit with BOP as described earlier under point 1 a) (ii) Top: Quick Union BOX d) Stuffing Box: Hydraulic wire line stuffing box with stuff assembly, blow out plug for 10,000 Psig working pressure of standard service for both 0.092 inch and 0.108 inch Piano wire complete with suitable sheave and bracket assembly. i) Connection: Bottom:Pin should be matched with top of lubricator riser BOX as described under point 1. c) (iv).Weight: The weight of the stuffing box should not be more than 25 kg. e) Hand Pump for Stuffing Box Assembly: Suitable hydraulic hand pump will be required for remote operation of Stuffing Box. The pump should be supplied along with 100 feet long hose with quick coupling to match with the hand pump and stuffing box. f) Consumable Spares: The following operational spares shall be supplied along with the equipment. i) Seal kit for Stuffing Box = 2 sets ii) Seal kit for BOP = 2 sets iii) BOP Inner Seal = 4 sets iv) 'O' ring for quick union for risers = 3 sets v) Back up ring for quick union for riser = 3 sets vi) Stuffing box packing = 30 nos. vii) Stuffing box Blow out plug = 5 nos. viii) Stuffing box sheave wheel bearing = 3 nos. ix) Stuffing box brass bushing = 10 nos. x) Repairing Kit for BOP Hand pump* = 2 nos. xi) Repairing Kit for Hydraulic Hand pump* = 2 nos. xii) Hose with quick union of 100 ft long = 1 no. xiii) 'C' Wrench for riser = 2 nos. |
| Bid Bond | INR 71,320.00 |
| Offer Validity | 90 days |
