| Reference | 3507 /2020 |
| Date | 8/10/2020 |
| Location | Middle East |
| Scope | The company announces its need for Main Distribution Power Center. 1- Main Distribution Power Center supplied with following specifications:- a- The M.D.P.C should be supplied by two incoming feeders and bus tie with auto-manual transfer b- Emergency generator circuit breaker should be supplied with mechanical & electrical interlock with both two incoming feeders c- Air circuit breakers with draw able type should be used for all Incomings, bus section and outgoing feeders d- The incoming, bus section & outgoing breakers are with manual and electrical closing mech. And should be contain their analogue ammeters, voltmeters selector switches, over current, earth fault and short circuit tripping device. e- Power factor correction on both sides to keep the P.F with the range 0.9-0.95 lag (the exist 300KVAR for each side) f- The MDPC should be with the following specifications:- 1- The switchgear rating at 50C° ambient. 2- Rated voltage l000v & Operating voltage 400v. 3- Short circuit level for 1 sec 80 KA. 5- Control voltage 220VAC, 50 Hz, phase +neutral. 6- Main incomers should be containing multifunction meter. 7- Ingress protection IP43 8- MDPC supply 2-Motor Control Center (MCC) Supplied with following specifications:- a- MCC provided with all required metering and indications. b-MCC contains the motors starters with draw able type for both Power and control cables, all starters D.O.L and provided with:- 1- High breaking capacity MCCB for short circuit protection. 2-Magnetic air breaks contactor. 3- Over load relay. 4- Analog ammeter as well as C.T for remote Ammeter. 5-Start, stop, and reset .B.P'S & Indication lamps for ON-OFF-TRIP. 6- Control voltage shall be 220V, 50HZ, C- The MCC should be with the following specifications:- 1- The MCC rating at 50°C ambient temp. &IP43. 2- Operating voltage 400v. 3- Rated voltage l000v. 4- Short circuit for 1 sec 80 KA. 5- Bus bar should be copper material and insulated with silver plated for all contact area. 6-- All starters should be containing remote start-stop facility. 7- Motor starter drawable unit should be normal unit (fully modular) & small drawable unit (1/4 width, 1/2 width) not acceptable 8- MCCS supply with quantities. |
| Bid Bond | US 19,000.00 |
| Bond Validity | 120 days |
| Offer Validity | 120 days |
| Documents Price | ID 250,000.00 |
